How do I replace an electric outlet where the wires are pushed into the outlet, not screwed to outlet? - outlet in spokan
I replaced before sale, but the son is screwed into the outlet side. This output is suppressed cable. Should I cut then screw on the side?
Sunday, December 13, 2009
Outlet In Spokan How Do I Replace An Electric Outlet Where The Wires Are Pushed Into The Outlet, Not Screwed To Outlet?
Subscribe to:
Post Comments (Atom)
4 comments:
Look in the back, next to go where the son in your device. You'll see a little crack there. Use a small flathead screwdriver and push at this point, while the cable pull.
One is a hot wire and the other is a reason .... them out of isolation and ensure that the cable box and secure and connect the cables, but make sure you know what the earth and what is the hot wire. Be careful.
The outputs of both hard and new fixtures. You are entitled to one of them. I like to bend the push-ins, because it is difficult, the cable to fit the taps.
The first type is correct, you can not a small screwdriver to remove them. But it is also the nearest exit as possible. This way, you have to play more yarn. Strip, the son again, and the last loop of wire and live again. You can stab in the back of a new one if the cable wrap 14AWG, but it is better to use the screws.
Remember:
White / Silver Neutral
Black and hot brass screws
Green / Bare is his country and goes to the green screw.
They did not cut son, t mess to try to save the plug is dead, cut, strip and make install
Post a Comment